DEEPSEA Auto Transfer Switch Control Module DSE705

The DSE705 is an Automatic Transfer Switch controller for genset and other applications

DSE705 Auto Transfer Switch Control Module

The DSE705 is an Automatic Transfer Switch controller for genset and other applications. The module will monitor the voltage and frequency of the incoming AC mains (utility) supply and in the event of a failure, will issue a start command to the generator control system.

Main features

KEY FEATURES

Automatic mains (utility) supply monitoring

Load changeover control

Manual start

Protected Solid State (PSS) outputs

Front panel mounting

Front panel programming

LED indicators

Configurable timers

Single/three phase mains (utility) sensing

Remote start input

KEY BENEFITS

Transfers between mains (utility) and generator power

On-site module configuration to match user requirements

Specification

DC SUPPLY

CONTINUOUS VOLTAGE RATING8V to 35V continuous

CRANKING DROPOUTSAble to survive 0V for 50mS, providing supply was at least 10V before dropout and supply recovers to 5V. This is achieved without the need for internal batteries.

MAXIMUM OPERATING CURRENT50mA

MAXIMUM STANDBY CURRENT50mA

ALTERNATOR INPUT RANGE75V(L-N) to 333V AC (L-N) absolutemaximum

ALTERNATOR INPUT FREQUENCY50Hz – 60Hz at rated engine speed(minimum:75V AC L-N)

OUTPUTS

START & RUN OUTPUTS1.2 Amp DC at supply voltage. Switches to battery negative when active

CLOSE GEN/MAINS (UTILITY)CONTROL OUTPUTS1.2 Amp DC at supply voltage. Switches to battery negative when active

AUXILIARY OUTPUTS1.2 Amp DC at supply voltage. Switches to battery negative when active

DEEPSEA Auto Transfer Switch Control Module DSE705